TAC DINE TD-Cartridge
Crack Repair Material for Damp or Oily Surfaces
A two-component epoxy resin product pressure-injected with the dedicated hand gun into cracks generally 2 mm or wider.
Basic specifications
- Product category
- Crack repair material for damp or oily surfaces
- Mixing ratio
- Base: hardener = 2:1
- Contents
- 300 ml base + 150 ml hardener
- Application guide
- Cracks generally 2 mm or wider
- Dedicated accessories
- Hand gun / C Plug / 24-stage mixer nozzle
Applications
Pressure injection into cracks
The resin is pressure-injected with the dedicated hand gun.
Damp or oily surfaces
Designed to cure where the application surface is damp or retains oil.
Dedicated application equipment
Used by combining the TD-Cartridge with the dedicated hand gun.
Performance data
Selection and application
Selection
For pressure injection into cracks generally 2 mm or wider where curing on a damp or oily surface is required.
Application
Remove removable water, oil, dust and weak material, then inject gradually with the dedicated hand gun.
Cartridge / 24-stage mixer-nozzle setup
The procedure below follows the TAC DINE cartridge and nozzle setup document and covers the 24-stage mixer-nozzle configuration used for discharge.
Prepare the cartridge
Remove it from the box and place it on a flat surface with the retaining cap facing upward.
Remove the cap and seals
Remove the retaining cap, then remove the semicircular seals from both the base and hardener cartridges.
Install the mixer nozzle
Attach the mixer nozzle to the outlet with the retaining cap. Orient it so the internal divider spans both outlets at a right angle to the alignment line.
Adjust the discharge rate
The assembly can be used for crack injection in this condition. To increase flow, carefully cut the nozzle tip with nippers or a large utility knife.
Documents
Documents are provided as original Japanese-language PDFs. Each card includes a concise English summary for orientation.
Illustrated Japanese setup guide for the cartridge, mixer nozzle and flat nozzle, including nozzle alignment, cutting precautions and the instruction to use the opened cartridge completely.
Japanese safety data covering composition and hazards, first aid, fire and spill response, handling and storage, protective equipment, disposal and transport for TD-Cartridge base and hardener.
One-page Japanese data sheet listing stated compressive, flexural and tensile strengths, bond strength and the 2:1 base-to-hardener mixing ratio.
Japanese consolidated guide covering TD-Cartridge specifications, pressure-injection procedure, safety precautions and stated physical-property values.